Uninstalling a roller blind is effortless. Curtains Dubai not only has Roller Blinds but also provide a clear explanation of how to remove them. If you are renovating your interiors, you may need to substitute the existing blinds with the new ones. The method of removal is different in curtains and blinds. Standard roller blinds roll the fabric to the top, while roller blinds at the top have a head that does not make the drapery visible. To remove blinds, knowledge on identifying and assembling the parts is vital. Even if you're not good at home renovation, this article with the uncomplicated procedure will guide you with all the steps.
Pull the chain to raise the blinds. It would make it easy to administer after the uninstallation. If your blinds are broken and couldn't be rolled upwards, turn the roller blinds counterclockwise by hand to fully retract them.
The chain safety buckle is attached to the wall of the chain tip. It is usually attached almost to the blinds and holds the chain that controls the position of the blinds. Insert the tip of the screwdriver into the screw head, turn it counterclockwise, and remove the screw.
Standard roller blinds have brackets on both sides to hold the roller in place. With pulley mounts, one of the mounts has a shaft that holds the drum and the other has a safety clip. You'll need to use a ladder to access the brackets on the right and then on the left.
When you find the holder with the clamp, which is usually "C" shaped, lift it. This will allow the coil to come out of the hole at the end of the cylinder.
Each bracket has a hole in which the roller is mounted. First, pull the side of the cylinder with the brackets out of the hole, then lift the opposite cylinder off the bracket. If the spring is loaded from one side and you need to slide it into the holder a little, you need to pull it out first.
Place the tip of a screwdriver on each screw and turn it counterclockwise until it is big enough to loosen. Discard the screws or save them for creative reuse. Once the screws come out, remove the brackets from the wall or window.
Before starting the removal process, pull on the chain to roll up the blinds. Fold the product regularly so that you can remove and store it.
The pulling device is a point system on one side of the blinds that you can use to open or close. This is usually on the right, but it can also be on the left depending on the blackout screen. Rotate the curtains before loosening the lower screws on the wall. Do the same for the connected piece above. It's usually on the right side of the right arch.
Place the flat end of the screwdriver in the space above the compartment between the cassette and the holder. Slide down or twist the screwdriver handle to open the hole so the cartridge comes out of the holder. Do this wherever the cartridge will contact the holder before completely removing the cartridge.
Turn the screw head counterclockwise as far as possible to loosen the screwdriver. Repeat this process for each nail on all brackets. Then remove the brackets from the wall and reinsert them.
These are tips for removing the curtain or drapes. Curtains Dubai provide clear information on how to remove roller blinds in Dubai homes.
